Ford Fiesta - changing the air filter and the coolant (antifreeze) *



Changing your car coolant - changing the air filter

Prepare your car for cold weather. If your engine has no antifreeze the coolant may solidify and crack your engine block. 
Undiluted coolant can protect your car down to about -30 ℃ (Ethylene glycol)
Coolant is not expensive and you should check your coolant periodically (every couple of years) especially if you live in an area where the temperature can drop below freezing.
You can get a small test gadget to test your antifreeze (coolant) for a couple of $$££.
Changing your car AIR FILTER is another simple job that is is very easy to do and will save you a trip to your service centre. 



Comments

Post a Comment

Popular posts from this blog

DIY Kits AT89C2051 SH-E 878 *

Image
DIY Kits AT89C2051  SH-E 878 lots of technical videos. https://sites.google.com/view/tecchie/home https://sites.google.com/view/fxv300tech/home Raspberry PI 4 for many videos and projects visit https://sites.google.com/view/fxv300tech/raspberry-pi-4
Read more

Connecting ONVIF camera to Xeoma Video Surveillance app using a Raspberry PI 4 *

Image
connecting an ONVIF camera to Xeoma Video Surveillance app using a Raspberry PI 4. This is my first project using the Raspberry PI 4. Raspberry PI 4 for many videos and projects visit https://sites.google.com/view/fxv300tech/raspberry-pi-4 Connecting ONVIF camera to Xeoma Video Surveillance app using a Raspberry PI 4 How to Configure a static TCP/IP IP Address - Raspberry PI 4 Building PI 4 using a GeekPI case for the Raspberry PI 2  PI 3 or P1 4 Temperature sensor script   Raspberry PI 4 Blinking Red LED on Raspberry PI 4 and Breadboard powering Using PI 4 GPIO signals to control a 74LS00 NAND Gate Wiring a 2 Way Switch Controlling 4N35 optocoupler using a GPIO signal from Raspberry PI 4 or Arduino Temperature sensor script using 74HC595 to output result to TIL311 display
Read more

Controlling 4N35 optocoupler using a GPIO signal from PI 4 or Arduino *

Image
Controlling 4N35 optocoupler using a GPIO signal from PI 4 or Arduino Controlling 4N35 optocoupler using a GPIO signal from Raspberry PI 4 or Arduino or any similar device which has General Purpose Input Output facilities (GPIO). Simple python script can be adjust for timing. The  4N35  is an optocoupler for general purpose application. It consists of gallium arsenide infrared LED and a silicon NPN phototransistor. What an optocoupler does is to break the connection between signal source and signal receiver, so as to stop electrical interference. check out my Raspberry PI projects. https://sites.google.com/view/fxv300tech/raspberry-pi-4/projects
Read more